Mercury – Gen I Throttle and Shift | 7 Ft | Mechanical Control Cable | 8M0085964

The Mercury Gen I throttle and shift cable is designed for Mercury mechanical control systems that require a balanced routing length without excess slack. It is commonly installed on compact consoles or side-mount setups where slightly more flexibility is needed to prevent tight bends during installation. The 7-foot length allows the cable to route cleanly while maintaining smooth, predictable control feel at the helm.

Selecting the correct cable length helps reduce internal resistance and unnecessary strain on the control system. A properly sized and routed Gen I cable supports consistent throttle response, clean shifting, and reliable long-term performance.

Key Features

• Gen I Mechanical Cable Design – Provides consistent throttle and shift response
• 7-Foot Cable Length – Balances reach and clean routing for compact helm layouts
• Low-Friction Inner Core – Helps maintain smooth, even control effort
• Mercury OEM Construction – Supports long service life and dependable durability
• Throttle & Shift Cable – Handles both throttle input and gear selection

Engine & Boat Compatibility

• Mercury outboards with Gen I mechanical control systems
• Mechanical throttle and shift control applications
• Compact consoles and side-mount control layouts

Important Notes

• Designed exclusively for Gen I mechanical control systems
• Always confirm required cable length before ordering
• Proper routing and adjustment are required for full throttle and shift travel

FAQs

1) What control systems does this cable work with?
This cable is designed specifically for Mercury Gen I mechanical throttle and shift control systems.

2) Is this a combined throttle and shift cable?
Yes. This single cable handles both throttle control and shifting.

3) When should I choose a 7-foot cable?
A 7-foot cable is ideal when slightly more routing length is needed than a 6-foot cable, without introducing excess slack that could affect control feel.

4) What happens if the cable is too short or too long?
An incorrect length can cause binding, stiff controls, poor routing, or premature wear.

5) Can this cable be used with Gen II controls?
No. Gen II control systems require Gen II-specific cables and are not compatible with Gen I cables.