Mercury – Power Center Harness (1.5 m) | Rigging Accessory | 84-8M0210394

Overview
This 1.5-meter harness connects the remote control post to the power center on 20–35E electric outboard setups. It’s a good fit for small boats where the power center sits a little farther away and the shorter harness just doesn’t reach comfortably. The extra length makes routing easier and keeps the wiring from feeling stretched or crammed into tight corners.

Key Features
 • 1.5 m Length – Extra reach for slightly wider helm layouts.
 • Remote-to-Power Center Link – Carries control and power signals cleanly between components.
 • Built for 20–35E Systems – Designed for Mercury’s smaller electric models.
 • Easy Routing – More flexibility when running through rig tubes or behind compact consoles.
 • OEM Connectors – Proper fitment with marine-grade insulation.

Engine & Boat Compatibility
 • Mercury 20E / 35E electric outboards
 • Remote control post installations
 • Power center modules
 • Small-to-mid-size electric boat layouts

Performance & Practical Benefits
The added length gives you a smoother wiring path and helps avoid tight bends that can cause problems later. With a clean, relaxed run, the system passes power and control signals reliably, and the helm area stays much easier to work around. It also makes future service simpler since you’re not digging through extra slack or improvised splices.

Why Buy OEM
OEM harnesses plug in the way they’re supposed to and hold up in real marine use. You get proper shielding, the right wire gauge, and connectors that stay tight instead of loosening up over time.

FAQ
Q1: When should I choose the 1.5 m version?
A: When the 1.0 m harness is just a bit too short for your console layout.

Q2: Do I need any setup after plugging it in?
A: No—SmartCraft picks it up automatically.

Q3: Is it fine for saltwater?
A: Yes. Just keep the connector ends rinsed and clean.

Q4: Anything to avoid during installation?
A: Don’t force sharp bends or run the harness over sharp edges.

Q5: What if the control post doesn’t respond afterward?
A: Check that both connectors are fully seated—most issues come from a loose plug.