Mercury – Tiller Power Harness (1.5 m) | Rigging Accessory | 84-8M0210363

Overview
This 1.5-meter tiller power harness connects the tiller cowl to the power center on 20–35E electric outboards. It’s made for setups where the 1.0 m harness is just a bit too short and you need a little extra room to route the cable cleanly. With the added length, the wiring lays more naturally and avoids the sharp bends or tight pulls that can cause problems later.

Key Features
 • 1.5 m Length – Offers extra reach for slightly wider or deeper rigging paths.
 • Tiller Cowl → Power Center Connection – Moves control and power signals between both components.
 • Sized for 20–35E Systems – Built specifically for these electric outboard models.
 • Flexible Routing – Easier to run through narrow rig tubes or tight tiller spaces.
 • OEM Connectors – Proper SmartCraft fit with marine-grade materials.

Engine & Boat Compatibility
 • Mercury 20E / 35E electric outboards
 • Tiller-handle boats
 • Power center modules
 • Small electric skiffs and compact rigs needing a bit more slack

Performance & Practical Benefits
The extra half-meter helps a lot when the components aren’t right next to each other. You can route the harness naturally, which keeps the wiring relaxed and reduces wear over time. A clean connection between the tiller and the power center also helps the system respond more consistently when you power up or change modes.

Why Buy OEM
OEM harnesses fit properly, use the right gauge wire, and hold up to vibration, spray, and everyday use. They stay seated, resist corrosion, and help avoid the random electrical quirks that show up with cheaper cables.

FAQ
Q1: When would I choose the 1.5 m harness?
A: When the 1.0 m cable is just a bit short for your tiller layout.

Q2: Any setup needed after plugging it in?
A: No—SmartCraft recognizes it automatically.

Q3: Good for saltwater use?
A: Yes. Just rinse the connectors during washdowns.

Q4: Anything to avoid during routing?
A: Don’t run it over sharp edges or squeeze it into tight pinch points.

Q5: What if the tiller stops responding afterward?
A: Check both connectors—loose plugs cause most issues.