Mercury – Thruster Cable (10 ft) | Rigging Accessory | 84-8M0174063

Overview
This 10-foot thruster cable gives you a simple, clean way to tie the thruster into the control system without extra loops of wire or tight squeezing. It’s made for short runs where you just need a solid, dependable connection. Once it’s in place, the thruster usually reacts a bit smoother when you’re easing into a slip or making small adjustments around the dock.

Key Features
 • 10-Foot Length – Handy for short, tidy rigging paths.
 • Thruster Connection Lead – Links the thruster to its control module.
 • Steady Signal Path – Helps keep thruster response consistent.
 • Marine-Grade Jacket – Built to handle spray, vibration, and heat.
 • OEM Fit – Designed to plug right into Mercury thruster systems.

Engine & Boat Compatibility
 • Bow and stern thrusters
 • Joystick Piloting for Outboards
 • Single-engine pontoon JPO boats
 • SmartCraft network setups

Performance & Practical Benefits
A cable that fits the distance correctly goes a long way—no stretched wires, no sharp bends, and fewer chances for odd behavior. With a clean run, the thruster picks up commands more naturally, which you’ll notice most when lining up at a dock or nudging the boat sideways in a breeze. It also keeps the rigging area neater and helps the cable last longer.

Why Buy OEM
OEM wiring fits the connectors the way it’s supposed to and holds up better in real-world boating conditions. The insulation, connectors, and overall build help you avoid the small but annoying electrical issues that cheap wiring often causes.

FAQ
Q1: When is the 10-foot cable a good fit?
A: When the thruster and control module are close enough that you only need a short, clean run.

Q2: Can I cut or splice it?
A: Not recommended—splices can corrode or weaken the signal.

Q3: Does it hold up in saltwater?
A: Yes, just keep the connectors clean as part of your washdown routine.

Q4: Anything to watch for during install?
A: Make sure the cable won’t rub against sharp edges or get pinched in the rigging tube.

Q5: What if the thruster still feels weak after install?
A: Check battery voltage, grounds, and main power connections—those are common trouble spots.