Mercury – Bezel (Black) | Flush-Mount Start/Stop Trim | 879315T01

Overview
This black bezel is the trim piece that finishes off a flush-mounted Mercury Start/Stop pad. It gives the switch a clean, finished look and keeps it sitting tight in the dash instead of shifting around. It works on anything from a single-engine setup to a quad, so you don’t have to worry about matching it to your layout. It’s a small part, but it makes the install look a lot more put-together.

Key Features
    • Flush-Mount Trim – Frames the Start/Stop pad with a clean, low-profile border.
    • Black Finish – Blends in easily with most helm panels.
    • Fits All Engine Counts – Works with single, dual, triple, and quad pads.
    • OEM Fit – Snaps in solid so the pad doesn’t wiggle or twist.
    • Clean Dash Look – Helps cover the cutout and keeps the install tidy.

Engine & Boat Compatibility
    • Single engine
    • Dual engine
    • Triple engine
    • Quad engine

Performance & Practical Benefits
A proper bezel keeps the Start/Stop pad firmly seated, which makes the buttons feel better under your fingers. It also helps keep water and grit from settling around the switch—something that definitely matters over time. And from a helm standpoint, it simply looks cleaner and more organized.

Why Buy OEM
OEM trim pieces fit right the first time and hold up to sun, vibration, and saltwater without warping or fading. No loose edges, no guessing on sizing—just a clean, solid fit that lasts.

FAQ
Q1: When do I need this bezel?
A: Anytime you're flush-mounting a Mercury Start/Stop pad and want the install to look clean and sit tight.

Q2: Does it need any setup?
A: Nope—snap it in and mount the pad behind it.

Q3: How does it handle saltwater?
A: Very well, especially with a quick rinse now and then.

Q4: Any install tips?
A: Make sure the dash cutout is clean so the bezel seats flat.

Q5: When should I replace it?
A: If it cracks, loosens up, or no longer holds the pad snug.