MerCruiser Sterndrive Installation Hardware

Choose a stern drive unit which you will be happy with. Sterndrives are a popular choice in boat propulsion systems with the inboard engine and outdrive unit working closely together.

Now all you need to do is test your boat and check that everything is working as it should be. Find many great new options and get the best deals for Mercruiser Sterndrive Installation Hardware. Mount the exhaust horn onto the boat, most models will have a back flow valve to protect the engine, if not then consider fitting an aftermarket valve. Check the water tightness of each hole passing out of your boat to make sure that no damage will be caused by using this stern drive unit. The transom shield needs to be connected up to the hydraulic lines in your boat. Bravo 2: The Bravo 2 sterndrive is designed for twin engine applications and can power a boat up to 55 mph for gas engines up to 450 HP. Position and fit the transom shield according to the manufacturers instructions. Kit includes six stainless steel nyloc nuts and six stainless steel washers for attaching the bell housing of MerCruiser stern drives. Loosen the bracket of the pump before fitting the hydraulic lines to prevent them from getting crushed or damaged. Whenever passing anything through the boat make sure that you use washers on both sides of the holes. A MerCruiser sterndrive is essentially a car or truck style engine mounted inside the boat, lower in the hull. The electrical panel needs to be fitted inside the transom shield as it's this which provides protection for the electrical circuits used. Complete Drive Install Kit. This is a type of inboard motor that benefits from many of the advantages of an outboard engine. In addition to triple-digit speeds, the exclusive performance torpedo design and dual water pickups allow the Bravo 1 to handle high and low speeds well. Quicksilver is the premier supplier of Mercury Marine Original Equipment replacement engine parts, oils, and accessories. The propeller itself is outside the hull and this looks the same as a normal outboard motor. These are all about the same but you will need to choose one which is compatible with your engine and suitable for your requirements. A sterndrive combines inboard power with outboard drive. There are many different examples of stern drive units from a wide range of different manufacturers. You should be able to benefit from enhanced maneuverability without having an ugly outboard motor on the back of your boat. A sterndrive is a marine propulsion system that is attached to a sterndrive, also known as an outdrive. Prepare the transom shield before attempting to fit the stern drive unit to the boat. The bottom system is the bit which contains all of the gears and the propeller. The engine sits just forward of the transom while the drive unit (outdrive or drive leg) lies outside the hull.