Mercury – Gen I Throttle and Shift Cable 19 Foot | Mechanical Engine Control | 8M0082492

The Mercury Gen I Throttle and Shift Cable (19 Foot / 5.8 m) is designed for boats using traditional Mercury Gen I mechanical control systems. This cable connects the control box to the engine to deliver direct, responsive throttle and shift movement without electronic involvement. The 19-foot length is ideal for wide-beam boats, deeper hulls, and long helm-to-engine routing where additional reach helps maintain clean, properly supported cable runs.

Mechanical control cables gradually wear as routing points flex, jackets age, and internal liners lose smoothness. Routine inspection for chafing, tight bends, corrosion at end fittings, and secure mounting can help reduce premature wear. Replacing a worn cable helps restore consistent throttle and shift response and supports safer operation during docking, close-quarters maneuvering, and everyday use.

Key Features

• Mechanical Throttle & Shift Operation – Delivers direct control movement without electronic delay
• 19-Foot (5.8 m) Cable Length – Supports clean routing in larger hulls and extended control layouts
• Gen I Control Interface – Designed for early Mercury mechanical control assemblies
• Marine-Grade Construction – Built to handle vibration, moisture, and everyday marine exposure
  
  

Engine & System Compatibility

• Mercury outboards
• Gen I mechanical control systems
• Mechanical throttle and shift setups
• Legacy Mercury control platforms
  
  

Important Notes

• Confirm Gen I mechanical control compatibility before ordering
• Verify correct cable length based on routing distance and helm position
• Avoid sharp bends, pinch points, and heat exposure during installation
• Proper adjustment is required for smooth operation and long service life
  
  

FAQs

1) What does a Gen I throttle and shift cable do?
It transfers throttle and shift movement from the control box to the engine using a mechanical cable.

2) When should a throttle and shift cable be replaced?
Replace the cable if you notice stiffness, delayed response, corrosion at fittings, or inconsistent shifting.

3) Why choose a 19-foot cable?
The 19-foot length is ideal for longer helm-to-engine runs where added reach helps maintain smooth routing and proper cable support.

4) Is this cable compatible with newer Gen II or Gen II+ controls?
No. This cable is designed specifically for Gen I mechanical control systems.

5) Why choose an OEM Mercury control cable?
OEM cables are built to Mercury specifications, helping ensure proper fit, smooth movement, and long-term durability.